Upcoming Trade Shows - March 2014
|IWA Outdoor Classics||Nürnberg Germany||March, 7 - 10 2014|
|Booth: Hall 5 - Stand 230||Messezentrum 90471|
Can you not make an upcoming Buy Group Show? Email us today to learn more about our Buy Group Specials that we will be offering at these shows. Customerservice@swab-its.com.
Use a Bore-tip to apply the solvent to the barrel. Then, after allowing the solvent time to work, brush the bore to break up any fouling. Next use a clean Bore-tip to push the fouling out the bore.
When the now dirty Boretip clears the bore, wet it with a little solvent and then squeeze it with an absorbent rag or paper towel, this will blot the dirt off. After blotting the Bore-tip should be clean enough to continue using to remove the fouling until you are finished cleaning.
When you are satisfied with the cleanliness of your barrel, use a clean Bore-tip to dry the bore. If you wish to lubricate you can use another Bore-tip to apply lubricant.
PLEASE NOTE: Always make sure the firearm is unloaded before cleaning. If you lubricate the barrel it must be dry swabbed before it is fired again. The bore should ALWAYS be clear and dry before firing.
For faster cleaning use mineral spirits. Apply mineral spirits to the Bore-tip and squeeze/blot into an absorbent rag or paper towel. When the Bore-tip is clean let dry and reuse.
Using soap and water, squeeze to blot out any excess solvent or dirt. Next, wash the Bore-tip with a grease cutting soap and warm water. Once clean, rinse then let dry completely.
Bore-tips® are a tough, reusable foam tips engineered for a tight bore fit that provides 360° of contact.
Manufactured by Super Brush, LLC, the leader in foam swab technology. All firearm cleaning swabs are proudly made in the U.S.A.
Bore-tips® perform better than patches and offer complete coverage and delivery of cleaning solvents and oils to the firearm. They are both reusable and can be washed, offering a very economical way to keep your firearm clean.